Nose

Turn on edge mode and select the outside edges of the nostril, hold down shift and drag out a new set of polygons then use the weld tool to weld the vertices together.

Select the edge mode and select the vertical edges around the nostril, but leave the one near the tip of the nose, at the edit edges panel, select connect setting and create a new set of segments.

Switch to vertex mode and use the cut tool to fix the five sided polygon.

Now I have to join the tip of the nose with the nostril, to do so I need to remove the edge between the tip of the nose and the nostril, select edge and click on the vertical edge that is blocking the path. Press backspace and select the cut tool again then join the vertex to the tip of the nose.

Select polygon, create and start from the middle vertex. Then create two polygons to fill the nostril.

Uses the extrude tool to move the polygon inside the nose.

For the lips I have used the same method as creating the nose, I select edge and click on all the edges at the mouth, choose select and uniform scale, hold down shift and drag out the polygon.

Select all the vertical edges around the lips, select connect setting and create a new set of segments. At the side view moves the new set vertices to match up with the reference plates and move the top vertices inward.

Turn on turbosmooth to see how’s the lips looks.

Again use the same method to create the eye lid and back of the face.

Eyes lids done, turn on turbosmooth to check.

Add the rest of the face by holding down shift and use the move tool to drag out new polygons and use target weld to weld them together.

Turn on turbosmooth to check.